Dynamic Fabric Building Configuration Example; Network Requirements; Configuration Procedure - HP 5920 series Configuration Manual

Principal switch running time information:
No interfaces available.
The output shows that the domain configuration is complete and that the runtime domain ID of
Switch B is 2.

Dynamic fabric building configuration example

Network requirements

As shown in
Figure 15 Network diagram

Configuration procedure

Configure Switch A:
1.
# Enable the fabric configuration function (optional, because this function is enabled by default),
and configure Switch A to operate in FCF mode.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
[SwitchA] vsan 1
[SwitchA-vsan1] domain configure enable
# Enable FCoE for VLAN 10 and map it to VSAN 1.
[SwitchA] vlan 10
[SwitchA-vlan10] fcoe enable vsan 1
[SwitchA-vlan10] quit
# Configure the domain ID as 11.
[SwitchA-vsan1] domain-id 11 preferred
Non-disruptive reconfiguration or isolating the switch may be performed. Continu
e? [Y/N]:y
[SwitchA-vsan1] quit
# Create interface VFC 1, bind it to interface Ten-GigabitEthernet 4/0/2, configure it to operate
in E mode, and assign it to VSAN 1 as a trunk port.
[SwitchA] interface Vfc 1
[SwitchA-Vfc1] bind interface ten-gigabitethernet4/0/2
Priority: 128
Figure 15, use the dynamic approach to build a fabric.
30