Verifying The Configurations - HP 5920 series Configuration Manual

# Enable the fabric configuration function.
[SwitchB] vsan 2
[SwitchB-vsan2] domain configure enable
# Configure the domain ID as 2.
[SwitchB-vsan2] domain-id 2 static
Non-disruptive reconfiguration or isolating the switch may be performed. Continu
e? [Y/N]:y
[SwitchB-vsan2] quit
# Enable FCoE for VLAN 10 and bind VLAN 10 to VSAN 2.
[SwitchA] vlan 10
[SwitchA-vlan10] fcoe enable vsan 2
[SwitchA-vlan10] quit
# Enable FSPF globally.
[SwitchB-vsan2] fspf enable
[SwitchB-vsan2] quit
# Enable FSPF for interface VFC 100.
[SwitchB] interface Vfc 100
[SwitchB-Vfc 100] port trunk vsan 2
[SwitchB-Vfc 100] undo fspf silent vsan 2

Verifying the configurations

# Display FSPF neighbor information on Switch A.
[SwitchA-Vfc 100] display fspf neighbor
FSPF neighbor information of VSAN 2(01):
Interface
Vfc 100
# Display information about the FC routing table on Switch A.
[SwitchA-Vfc 100] display fc routing-table vsan 2
Routing Table: VSAN 2
Destinations : 5
Destination/mask
0x020000/8
0xfffc01/24
0xfffffa/24
0xfffffc/24
0xfffffd/24
# On Switch A, use the fcping command to ping Switch B and check whether Switch B is reachable.
[SwitchA-Vfc 100] fcping fcid fffc02 vsan 2
FCPING fcid 0xfffc02: 128 data bytes, press CTRL_C to break.
Reply from 0xfffc02: bytes = 128 time = 1.102 ms
Reply from 0xfffc02: bytes = 128 time = 0.276 ms
Reply from 0xfffc02: bytes = 128 time = 0.253 ms
Reply from 0xfffc02: bytes = 128 time = 0.270 ms
Reply from 0xfffc02: bytes = 128 time = 0.247 ms
--- 0xfffc02 fcping statistics ---
NbrDomain IfIndex
2 0x68
Routes : 5
Protocol Preference
FSPF 20
DIRECT 0
DIRECT 0
DIRECT 0
DIRECT 0
NbrIfIndex Dead Time
0x68 00:01:06
Cost Interface
265 Vfc 100
0 InLoop0
0 InLoop0
0 InLoop0
0 InLoop0
51
State
Full