Step
3.
Configure a
downlink-to-uplink
interface mapping.
Initiating a disruptive load-balancing process
CAUTION:
This feature redistributes downlink traffic across all uplink interfaces for better load balancing, but it
causes traffic interruption.
If interfaces in a VSAN are not distributed evenly, you can use this feature to force all nodes in the VSAN
to relog in to the core switch.
To initiate a disruptive load-balancing process:
Step
1.
Enter system view.
2.
Enter VSAN view.
3.
Initiate a disruptive load-balancing process.
Displaying and maintaining NPV
Execute display commands in any view.
Task
Display the nodes on downlink interfaces and their
mapped uplink interfaces.
Display the traffic mapping information.
Display status information.
NPV configuration example
Network requirements
As shown in
Command
npv traffic-map server-interface
interface-type interface-number
external-interface interface-type
interface-number
Figure
26, configure Switch A (edge switch) as an NPV switch to expand the network.
Remarks
By default, no mapping is configured.
Command
system-view
vsan vsan-id
npv load-balance disruptive
Command
display npv login [ vsan vsan-id ] [ interface
interface-type interface-number ]
display npv traffic-map [ vsan vsan-id ] [ interface
interface-type interface-number ]
display npv status [ vsan vsan-id ]
71