Verifying The Configurations - HP 5920 series Configuration Manual

[SwitchB-vsan1] domain-id 2 static
Non-disruptive reconfiguration or isolating the switch may be performed. Continu
e? [Y/N]:y
[SwitchB-vsan1] quit
# Enable FCoE for VLAN 10 and bind VLAN 10 to VSAN 1.
[SwitchB] vlan 10
[SwitchB-vlan10] fcoe enable vsan 1
[SwitchB-vlan10] quit
# Configure two static routes.
[SwitchB-vsan1] fc route-static 010000 8 Vfc200
[SwitchB-vsan1] fc route-static 030000 8 Vfc201
Configure Switch C:
3.
# Configure Switch C to operate in FCF mode and bind interface VFC 300 to interface
Ten-GigabitEthernet 1/0/3.
<SwitchC> system-view
[SwitchC] fcoe-mode fcf
[SwitchC] interface Vfc 300
[SwitchC-Vfc300] bind interface Ten-GigabitEthernet1/0/3
[SwitchC-Vfc300] fc mode e
[SwitchC-Vfc300] port trunk vsan 1
[SwitchC-Vfc300] quit
# Enable the fabric configuration function.
[SwitchC] vsan 1
[SwitchC-vsan1] domain configure enable
# Configure the domain ID as 3.
[SwitchC-vsan1] domain-id 3 static
Non-disruptive reconfiguration or isolating the switch may be performed. Continu
e? [Y/N]:y
[SwitchC-vsan1] quit
# Enable FCoE for VLAN 10 and bind VLAN 10 to VSAN 1.
[SwitchC] vlan 10
[SwitchC-vlan10] fcoe enable vsan 1
[SwitchC-vlan10] quit
# Configure two static routes.
[SwitchC-vsan1] fc route-static 010000 8 Vfc300
[SwitchC-vsan1] fc route-static 020000 8 Vfc300

Verifying the configurations

# Display the FC routing table in VSAN 1 on Switch A.
[SwitchA-vsan1] display fc routing-table vsan 1
Routing Table: VSAN 1
Destinations : 6
Destination/mask
0x020000/8
0x030000/8
0xfffc01/24
Routes : 6
Protocol Preference
STATIC 10
STATIC 10
DIRECT 0
48
Cost Interface
0 Vfc100
0 Vfc100
0 InLoop0