Troubleshooting - Jura GIGA X8 Professional Original Instructions For Use

7 Troubleshooting

Problem
Insufficient foam is
produced when the milk
is frothed, or milk sprays
from the dual spout.
Coffee only comes out in
drips when it is being
prepared.
'Fill bean container.'
not displayed although
the bean container is
empty.
Preparation stops, 'Fill
bean container.' is briefly
displayed although the
bean container has been
filled.
'Empty drip tray.' is
always displayed.
'Fill water tank.' is
displayed although the
water tank is full.
Cause/Result
The dual spout is dirty.
Coffee or ground coffee has
been ground too finely and
is blocking the system. The
same filter cartridge may
have been used several
times or the water hardness
set incorrectly in the
programming mode.
is The bean monitor is dirty.
The sliding catch for the
bean container has not been
pulled out or has not been
pulled out completely.
The metal contacts of the
drip tray are dirty or wet.
The water tank float is
trapped.
Action
T Rinse and clean the dual spout (see
Chapter 5 'Maintenance – Cleaning
the milk system').
T Put the grinder on a coarser setting
or use coarser ground coffee (see
Chapter 4 'Permanent settings in
programming mode – Setting the
consistency of grind').
T Perform descaling (see Chapter 5
'Maintenance – Descaling the
machine ').
T Clean the bean container (see
Chapter 5 'Maintenance – Cleaning
the bean container').
T Open the service cover on the back
of the machine and pull the sliding
catch all the way out (see Chapter 5
'Maintenance – Cleaning the bean
container').
T Clean and dry the metal contacts on
the back of the drip tray.
T Descale the water tank (see Chap-
ter 5 'Maintenance – Descaling the
water tank').
7 Troubleshooting
55