Page 1
Fitting Guide Roger and Cochlear™ Baha® Sound Processors This guide provides detailed information on how Roger X should be used with Cochlear™ Baha® Sound Processors Generation 3 and Generation 4 to achieve the best possible performance. Set-up The table below shows what is required to connect a Cochlear Baha sound processor to a Roger X receiver.
Page 2
Pre-fitting for Baha® 4 Sound Processor Launch the Cochlear Baha® Fitting Software 4.0 SR1, enter the Fine Tuning screen and activate the DAI + Mic program for the Baha 4 Sound Processors. 3. Save 1. Select “DAI + Mic” on a program slot of your choice.
Pre-fitting for Baha® 4 Sound Processor when used with Roger MyLink 1. Activate the “Telecoil + Mic”program 3. Save 2. Ensure, the “Mic relative DAI / Telecoil (dB)” is set to 0 dB Cochlear Baha® Fitting Software 4.0 SR1 (4.0.0.5132) Fitting Guide | Roger and Cochlear™ Baha® Sound Processors...
Roger X (less than 10 cm/4 inches) and press Check. -8 to +8 dB. Roger X information will appear on the inspiro’s screen. Available for Roger X (02) only Fitting Guide | Roger and Cochlear™ Baha® Sound Processors...