Airwell AWSI YIFA060–H13 Service Manual page 13

6.3 Indoor wire connection
Remove electric control box cover of indoor unit connect the wires in accordance with the electric diagram
mentioned on the back of the cover. The wire ends must be tightly fixed into terminal boards without ease. The
earth wire must be fixed into appointed position.
6.4 Outdoor wire connection
 Remove the electric item cover, which is positioned in the right side of outdoor unit, connect the wires in
accordance with the electric diagram on the back of the cover.
 Be sure that pressing the wires tightly with the terminal boards while it through the board, the wire ends must be
tightly fixed into terminal boards. The earth wire must be fixed into appointed position.
 After all the wire connected, bundle connection pipe, connection wires and drainage pipe with strips like
mentioned drawing below:
Notice

Compressor of AL-C(H)36/5R1(U), AL-C(H)48/5R1(U), AL-C(H)60/5R1 (U) is 3 phase power supply
and the outdoor PCB with phase sequence protection. Please be careful with wire connection.

Be sure don't make the drainage pipe flat while bundled!
ELECTRICAL DATA
12 | S e r v i c e M a n u a l