Installing The Final Polishing Filter - Aquasafe Home II Installation Instructions Manual

8.0 Installing the Final Polishing Filter

Push the two clips (found in the Large Parts Bag) onto the R.O. Membrane housing in preparation for
the Final Polishing Filter (step 1, Fig 14).
Now push the Final Polishing Filter into the canister clips (step 2, Fig. 14). The direction of the Final Pol-
ishing Filter is important. YOU MUST HAVE THE TEXT UPSIDE DOWN. PLEASE NOTE: The reason for in-
serting the Final Polishing with the text upside down is so the Blue hose will easily reach the "T" adap-
tor. You will notice an arrow engraved on the polishing filter which indicates the direction of water
flow. The "T" adaptor should always be inserted on the opposite side of the polishing filter to which the
arrow is pointing. In this way water will flow from the water Storage Tank, through your Final Polish-
ing Filter, then to your Aquasafe Faucet every time you take water from the system. The Final Polishing
Filter remineralizes your water to ensure it has a full-bodied taste. Because of this the ppm of the water
dispensed at your Aquasafe faucet will be higher than that coming out of the R.O. Membrane.
Figure 14
Attaching the
Final Polishing
Filter
Take the male "T" adaptor from the Small Parts Bag and screw it into the left side of the Polishing Filter.
Then take the straight male adaptor from the small parts bag and screw it into the right side of the
Polishing Filter (steps 1 & 2 in Fig 15). Remember to apply 4-7 wraps of Teflon tape.
Next, Insert the short blue hose connected to the "OUT" side of the 4 way ASV (Automatic Shut Off
Valve) and push it into the "T" Adaptor on the left side of the Polishing Filter (step 3, Fig 15).
1
Figure 15
Attaching the
Final Polishing to
the D.I. Canister
male 'T'
adaptor
1
Push 2 canister clips onto
the R.O. Membrane housing
www.aquasafecanada.com
Connect the male 'T' adaptor to the left side
of the Polishing Filter
www.aquasafecanada.com
www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 9
2
straight
male adaptor
2
Connect the
straight male
adaptorto the
right side of the
Polishing Filter
Push the Final Polishing lter down onto the
canister clips. Ensure the writing on the
Polishing lter is upside down.
www.aquasafecanada.com
3
Connect the short blue Permeate water line
coming out of the ASV to the elbow adaptor
on the left side (as viewed from the front) of
the Final Polishing Filter
4 way auto
shut-o valve
(ASV)
NOTE:
Back View -
hanging
bracket
not shown
for clarity