Table of Contents
Advertisement
Quick Links
- 1 Relax, Take Your Time. You will Find this Process Easy and Straight Forward
- 2 Preparing the Feed Water to Your System
- 3 Flushing of the Pre-Filters
- 4 Setting the Flow Restriction Ratios of Your System
- 5 Home II System Filter Change Schedule
- 6 Pre-Filters - How to Conduct a Filter Change
- Download this manual
See also:
Instruction and Installation Manual
Home II Reverse Osmosis System
This Aquasafe Reverse Osmosis System has been specifically
designed as a DIY (Do It Yourself ) unit for easy installation and
maintenace purposes. You will insure a successful installation as
well as reliable operation by carefully reading this manual and
following its operational guidelines.
Your system requires a minimum of 50psi inlet water pressure.
City and municipality water utilities are mandated to provide a
minimum of 50psi however sometimes this is not what results.
If you are on a well system or on city/municipal water supply and
have less than 50psi we highly recommend a fully automatic
booster pump which is found on our websites general parts
and accessories page. We also highly recommend a booster
pump if your water is extremely turbid with ppm counts beyond
600ppm.
www.aquasafecanada.com | sales@aquasafecanada.com | 1-888-942-0226
Installation Instructions for:
Installation Instructions Pre-amble.
Home II Reverse Osmosis System COMBO
The installation instruction that follow are extremely detailed.
if a leak is experienced during installation, please see the Leak
Prevention Section on page 15.
ATTENTION:
It is extremely important to change the
filters of your system in order to ensure ultra pure water
is being produced for you and your loved ones, (which
is the whole point to your system) and also to prevent
premature fouling of the TFC Filmtec Reverse Osmosis
Membrane of your system. After your installation is complete,
please read over the Filter Change Schedule section (page
16) and remember to mark on your calendar when your
systems filter changes need to be conducted. Filter changes on
Aquasafe's Reverse Osmosis Systems are both inexpensive and
very easy to do.
Advertisement
Table of Contents
Related Manuals for Aquasafe Home II
Summary of Contents for Aquasafe Home II
- Page 1 Home II Reverse Osmosis System Home II Reverse Osmosis System COMBO Installation Instructions Pre-amble. This Aquasafe Reverse Osmosis System has been specifically The installation instruction that follow are extremely detailed. if a leak is experienced during installation, please see the Leak designed as a DIY (Do It Yourself ) unit for easy installation and maintenace purposes.
-
Page 2: Table Of Contents
Home II System Filter Change Instructions ........ -
Page 3: Relax, Take Your Time. You Will Find This Process Easy And Straight Forward
Pure water outlet to faucet, icemaker etc. of membrane houseing Aqua-safe 5th Stage exclusive E-Z Flush Final Polishing Filter Flow Restrictor for taste 4th Stage Membrane Housing waste water drain www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 1... -
Page 4: Take Everything Out Of The Box
Now, using the large canister wrench from the Large Parts Bag, tighten each of the prefilters with reasonable force in order to seal the filters into place. page 2 | Home II Installation Instructions 05/13 | www.aquasafecanada.com... -
Page 5: Inserting The R.o. Membrane
NO cold water flowing from your kitchen sink faucet. If you shut the valve off correctly, there should be no cold water flowing. www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 3... -
Page 6: Special Note About Braided Wire Plumbing
The blue “C” clip holds the collet in its proper position while the system is in operation. page 4 | Home II Installation Instructions 05/13 | www.aquasafecanada.com... -
Page 7: Piercing The Cold Water Line
4th stage (Reverse Osmosis Membrane) ensuring maximum life span of the Reverse Osmosis Membrane. www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 5... -
Page 8: Membrane Feed Water Line Hook-Up (Pre-Filter To R.o. Membrane)
Manual short white Shut-O Valve auto shut-off tube to elbow valve on OUTPUT side NOTE: Back View - hanging of pre- lters bracket not shown for clarity page 6 | Home II Installation Instructions 05/13 | www.aquasafecanada.com... -
Page 9: Setting The Flow Restriction Ratios Of Your System
LY until the amount of BRINE water flowing through the E-Z Flush Flow Restrictor is flowing THREE TIMES FASTER than that of the PERMEATE water flow coming out of the RO Membrane. In this way www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 7... - Page 10 SHOULD ALWAYS HAVE MORE BRINE WATER FLOW THEN PERMEATE WATER FLOW. For your convenience this system is fully automatic! When you draw water from the Aquasafe faucet, the system will auto-fill its holding tank and then shut off until more water is drawn from the sys- tem where the cycle would then repeat.
-
Page 11: Installing The Final Polishing Filter
In this way water will flow from the water Storage Tank, through your Final Polish- ing Filter, then to your Aquasafe Faucet every time you take water from the system. The Final Polishing Filter remineralizes your water to ensure it has a full-bodied taste. Because of this the ppm of the water dispensed at your Aquasafe faucet will be higher than that coming out of the R.O. -
Page 12: Prepare The R.o. Water Holding Tank
Stand the unit inside a drip pan. Disposable aluminum baking sheets work fine. We suggest this because you may have water drips while servicing the system or when you change out filters. page 10 | Home II Installation Instructions 05/13 | www.aquasafecanada.com... -
Page 13: Preparing The Discharge Water Saddle Clamp
1/2 inch rubber gasket rubber gasket drain pipe www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 11... -
Page 14: Installing The Faucet
10.0 as seen above for your faucet installation. When you have your Aquasafe faucet firmly in place in the chosen location, insert the hose leading from the faucet into the straight male adaptor on the left side of the Polishing Filter. -
Page 15: Extra Information For The Home Ii Combo
Where do I install the PSI Meter from my “COMBO” System? The PSI Meter If you have purchased the Home II System Combo, your system came with a PSI Meter as seen in Figure 21. It is not necessary that the PSI Meter be installed onto your system. -
Page 16: How Do I Use The Tds Meter From My "Combo" System
Your case of 21 pre-filters (6 full changes) can be stored in the same state in which they arrived. Each prefilter comes wrapped in protective plastic. Store at room temperature. Shelf life is years. page 14 | Home II Installation Instructions 05/13 | www.aquasafecanada.com... -
Page 17: Leak Prevention Page
Pre-Filter Housing can be easily fixed by tight- ening with the system’s “large Canister Wrench”. Large Canister Wrench A “Large Canister Wrench” came with the Original Purchase of your Reverse Osmosis System Pre-Filter Housing www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 15... -
Page 18: Home Ii System Filter Change Schedule
Stage 4 – When should I change the reverse Osmosis Membrane? The R.O. Membrane is the very heart of your Aquasafe Reverse Osmosis System. The R.O. Membrane is rated for 4000-5000 Gallons of purified water production. A new R.O. Membrane will last for approxi- mately 3-4 years. -
Page 19: Testing To See If Your R.o. Membrane Needs Replacing
Are you unsure when your replaced the R.O Membrane Last? Aquasafe highly recommends you replace your Reverse Osmosis Membrane if you have never changed the R.O. Membrane of your system and your system is more than 3 years old or if you cannot remember the last time you have replaced your R.O. -
Page 20: Stage 5 - When Should I Change The Final Polishing Filter
Move on to the pre- lter ush. Once you have finished tightening the third and final pre-filter housing to the main system, you will need to conduct a “pre-filter flush”. page 18 | Home II Installation Instructions 05/13 | www.aquasafecanada.com... -
Page 21: Membrane - How To Change The R.o. Membrane Of Your System
The fourth stage of your system is the Reverse Osmosis Membrane (Dow Filmtech Material R.O.) 0.00001 Micron. For your convenience, the Reverse Osmosis Membrane offered by Aquasafe will fit perfectly into any Reverse Osmosis System Aquasafe has offered in the past, currently does offer or will offer in the future. - Page 22 Allow the tank to fill and empty this down the drain via the faucet. Allow the tank to fill one more time and drain this as well. You can now enjoy your purified water once more. This concludes the steps to change the Reverse Osmosis Membrane of your system. page 20 | Home II Installation Instructions 05/13 | www.aquasafecanada.com...
-
Page 23: Final Polishing Filter - How To Change The Final Polishing Filter
This concludes all filter change instructions for the Home II System. Please check on your system every hour after the filter change for the first three to four hours inspecting for any potential small leaks. -
Page 24: Water Systems & Parts Warranty Information
Aquasafe. The structural problem must be made safe Systems to any further liability or obligation than those stated aware to Aquasafe no more then 30 days after delivery of product and on this form. all defective filters must be returned to Aquasafe.