Table of Contents
Advertisement
9.0 Installing the Final Polishing Filter
Push the two remaining canister clips (found in the Large Parts Bag) onto the R.O. Membrane housing
in preparation for the Final Polishing Filter (step 1, Fig 16). You can rotate the Remineralization Car-
tridge back out of the way to make room.
1
Push 2 more canister clips onto the
Figure 16
R.O. Membrane housing and push
the Final Polishing Filter into place
Attaching the
Final Polishing
Final Polishing Filter
Filter
www.aquasafecanada.com
Now push the Final Polishing Filter into the canister clips (step 1, Fig. 16). The direction of the Final
Polishing Filter is important. THE TEXT SHOULD BE RIGHTSIDE UP so that the arrow on the cartridge in-
dicates the direction of water flow. Take the straight male adaptor from the Small Parts Bag and screw
it into the left side of the Final Polishing Filter. Then take the male "T" adaptor from the small parts bag
and screw it into the right side of the Final Polishing Filter (step 2 & 3, Fig 16) Remember to apply 4-7
wraps of Teflon tape.
Take the 4 inch piece of blue tubing
Figure 17
from the Small Parts Bag and insert
Attaching the
one end into the elbow adaptor on
Remineralization
the right side of the Remineralization
Cartridge to the
Cartridge and the other end to the
male "T" adaptor on the right side of
Final Polishing
the Final Polishing Filter (Fig. 17).
Filter
The Final Polishing Filter remineral-
izes your water to ensure it has a
full-bodied taste. Because of this the
ppm of the water dispensed at your
Aquasafe faucet will be higher than that coming out of the R.O. Membrane.
10.0 Prepare the R.O. Water Holding Tank
The R.O. Water Holding Tank has an air bladder and a water bladder inside it. The air bladder comes
pre-set from the factory at 7 PSI for your convenience. CAUTION: Changes to the PSI of the air bladder
inside the R.O Water Holding tank may cause harmful back pressure which can result in the Auto Shut-
Off Valve (ASV) malfunctioning. As such, please do not attempt to adjust the air pressure of your R.O
Water Holding tank. Please note: For your convenience, the R.O Water Holding tank can stand up or
lay horizontal to conserve space if necessary.
page 10 | Home II + Remineralization Installation Instructions 08/13 | www.aquasafecanada.com
note the
direction of the
ow arrow
straight
Remineralization
male
Cartridge
adaptor
rotated back
to make room
Use a 4 inch piece of blue tubing to connect the Remineralization
Cartridge and the Final Polishing Filter as shown.
to
ASV
2
Connect the straight male adaptor to the left side
of the Final Polishing Filter
Final Polishing Filter
www.aquasafecanada.com
Final Polishing Filter
male 'T'
adaptor
3
Connect the
male "T" adaptor
to the right side of the
Final Polishing Filter
( lters shown
side by side and
without canister
clips for clarity)
Hide quick links:
Advertisement
Table of Contents
