Table of Contents
Advertisement
Rubber Spacer
Figure 20
Attaching the
Cover Plate
faucet
Rubber Seal
tubingfound on the feed water line to its "OFF" position. The nature of water is to find the path of least
resistance. Some initial small leaks are not unheard of. If a leak does occurs at any time please see
Aquasafe's LEAKS PREVENTION SECTION on the page 15 of this document.
GET A GOOD FLASHLIGHT AND CHECK OVER THE ENTIRE SYSTEM CAREFULLY WHEN COMPLETED TO
SPOT ANY POTENTIAL LEAKS.
¬
Congratulations on completing the installation process. You may now start drinking the ultra puri-
fied drinking water you desire for the health and enjoyment of you and your loved ones.
If you require further clarification after going through all of the information of these instructions,
please feel free to email Aquasafe for further support at: techsupport@aquasafecanada.com
Extra information for the Home II COMBO
Figure 21
Where do I install the PSI Meter from my "COMBO" System?
The PSI Meter
If you have purchased the Home II System Combo, your system came with
a PSI Meter as seen in Figure 21. It is not necessary that the PSI Meter be
installed onto your system. The PSI Meter is provided as a convenience to
you as your entire system operates from water pressure. If need be, the
PSI Meter allows you to determine the water pressure at any point on your
Reverse Osmosis System which can make troubleshooting of any potential
problems on your system extremely easy. However, if you chose to install
the PSI Meter onto your system, there are two main areas where installing
Gooseneck
Plastic Ring
Steel Washer
Plastic Ferrule
Compression Nut
tighten this nut over the threads
under the faucet
www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 13
Counter Top
threads
Blue tubing
Hide quick links:
Advertisement
Table of Contents
