Preparing The Discharge Water Saddle Clamp - Aquasafe Home II Installation Instructions Manual

11.0 Preparing the Discharge Water Saddle Clamp.

Find a location on the drain pipe under
Figure 18
your sink where you wish to secure the
discharge water saddle clamp found
Where to install
in your Large Parts Bag (Fig. 18). Make
the drain saddle
sure—MAKE REALLY SURE — that the
clamp
location you have chosen is above the
trap! (The trap is the "U" shaped part
of the drain pipe) You may secure the
saddle clamp on a horizontal pipe JUST
AS LONG AS YOU ARE ABOVE THE TRAP!!!
Also try to secure the saddle clamp
where it will not block anything, like
where you want to put your system or
the R.O. Water Holding Tank.
Drill out your chosen spot with a 1/4 inch drill bit. The 1/4 inch hole that you drill into the carefully
chosen location on your drain pipe is where the yellow discharge line will be inserted into and secured
into place with the discharge water line (Drain) Saddle Clamp.
Take the gasket that came with your Large Parts Bag and remove the backing. Then stick the gasket to
the inside of the saddle clamp making sure that the yellow tubing is showing through at least 1/2 inch
(Fig. 19). Now secure the saddle clamp in its chosen location firmly making sure the tubing is inserted
into the drain pipe. Attach the other end of the yellow discharge line to the E- Z Flush Flow Restrictor
on the back of the unit.
The material of the Drain Saddle Clamp is flexible. If your drain pipe is slightly larger than the cir-
TIP
cumference of the drain saddle clamp simply press the saddle clamp firmly onto the drain in order
to catch the bolts on the opposite side. You only need to tighten the bolts to the point where the
gasket begins to compress against your drain pipe.
1 Insert yellow drain line
Figure 19
into quick connect tting
Assembling and
attaching the
Remove the backing
2
from the gasket and
drain saddle
stick it to the inside of
clamp
the saddle clamp
making sure that the
yellow tubing is
showing through at
least 1/2 inch
OK
NOT OK
rubber gasket
www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 11
sink
You can install the
saddle clamp on
horizontal
or vertical pipes
Do NOT install the drain saddle
clamp inside the dashed line area.
Trap
It MUST be installed above the trap
yellow drain
line
quick connect
tting
rubber gasket
drain pipe
sink
OK