Table of Contents
Advertisement
9.0 Prepare the R.O. Water Holding Tank
The R.O. Water Holding Tank has an air bladder and a water bladder
Figure 16
inside it. The air bladder comes pre-set from the factory at 7 PSI for your
convenience. CAUTION: Changes to the PSI of the air bladder inside
Attach the tank
the R.O Water Holding tank may cause harmful back pressure which can
top valve to the
result in the Auto Shut-Off Valve (ASV) malfunctioning. As such, please
R.O. Water
do not attempt to adjust the air pressure of your R.O Water Holding
Holding Tank
tank.
Please note: For your convenience, the R.O Water Holding tank can
stand up or lay horizontal to conserve space if necessary.
Screw the tank top valve found in your Small Parts Bag onto the threads
found on top of the R.O Water Holding Tank (Fig. 16). Remember to
apply 4-7 wraps of Teflon tape to the thread of the tank itself.
PLEASE NOTE: The long length of blue tubing used to flush your prefilters is the tubing you will use to
hook up both the water storage tank as well as the dedicated Reverse Osmosis faucet that came with
your system.
You will need to cut this length of blue tubing in two pieces accordingly. The length of tubing used to
hook up your kitchen faucet (which will be attached to the left side of the Polishing Filter) will prob-
ably need to be longer than the length of blue tubing used to hook up your R.O Water Holding tank
(which will be attached to the right side of the Polishing Filter). Take a moment and judge how much
Figure 17
Attach the tank
top valve to the
Final Polishing
Filter
10.0 Clear the Decks.
If you have not already done so, the next step is to totally clean out under your sink. Get some rags to
wipe up any water drips that may be present from the installation process. Now, step back and look at
where you want the unit and the tank positioned. Please remember, you have to service the system so
consider accessibility.
TIP
Stand the unit inside a drip pan. Disposable aluminum baking sheets work fine. We suggest this
because you may have water drips while servicing the system or when you change out filters.
page 10 | Home II Installation Instructions 05/13 | www.aquasafecanada.com
Connect the Polishing Filter to the tank top valve
using a length of blue tubing cut to t your setup
tubing you will need for each purpose
based upon where the final placement
of your system will be located under
your sink (or the like) and then cut the
blue tubing to length with a sharp
knife making sure your cut is straight
(not at an angle).
www.aquasafecanada.com
Now insert one end of the cut length
of blue tubing (for the tank) into the
male "T" adaptor found on the left side
of the Final Polishing Filter and the
other end into the tank top valve con-
necting the holding tank to the system
(Fig. 17).
Hide quick links:
Advertisement
Table of Contents
