Final Polishing Filter - How To Change The Final Polishing Filter - Aquasafe Home II Installation Instructions Manual

Final Polishing Filter - How to change the Final Polishing Filter

This is the final filtration stage in your R.O. System. The Final Polishing filter is rated for 1800-2000
gallons of purified water production and therefore should be changed every second time you change
your three pre-filters.
1
Depressurize your system (see Fig. 23)
Figure 30
Replacing the
2
Remove (see Fig. 10) the three tubes
Final Polishing
from the ttings on either side of your
used nal polishing lter.
Filter
to tank
5
Attach the new nal polishing lter by reversing steps 3 and 2. It does not
matter which outlet of the male 'T' adaptor connects to the tank and which
to the D.I. Resin canister. The straight male adaptor connects to the faucet.
6 Turn on the Manual Shut-O Valve and Tank Top Valve to repressurize your system.
PLEASE NOTE: A new Final Polishing Filter discharges a larger amount of access carbon during its rst 1 to
1.5 gallons of use. Please ush out the nal polishing lter by allowing the tank to ll then empty the whole
tank down the drain through the faucet.
This concludes all filter change instructions for the Home II System. Please check on your system every
hour after the filter change for the first three to four hours inspecting for any potential small leaks.
If any drips are detected please see our Leak Prevention Page (page 15) which will explain how to
quickly and easily fix all potential leaks.
Please do not hesitate to contact if you should need further assistance.
• Phone: (Toll Free) 1-888-942-0226
• Skype: Aquasafe
• Email: sales@aquasafecanada.com
Thank You for choosing Aquasafe Systems, we greatly value your business!
to faucet
www.aquasafecanada.com
www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 21
3
Pull the nal
polishing lter out
of its clips.
www.aquasafecanada.com
4
Unscrew the straight male
adaptor and the male 'T'
adaptor from either end
of the old lter and insert
them into the new lter.
Pay attention to the
direction of the arrow on
the polishing lter and
insert them on the same
side (T adaptor on the
side closest to the base of
the arrow) they were on
before.
Old Filter
New Filter