Membrane - How To Change The R.o. Membrane Of Your System - Aquasafe Home II Installation Instructions Manual

Step 2. Flushing the Pre-Filters (Fig. 26)
All water filters throughout the water filtration industry should be flushed out before final use to rinse
away any initial loose particulates from the manufacturing process. This process is very easy.
1
Disconnect (see Fig. 10) the white tubing from the third
Figure 26
pre- lter housing and the yellow tubing from the output
side of the E-Z Flush Flow Restrictor
Flushing the
pre-filters
NOTE:
Back View -
hanging
bracket
not shown
for clarity
4
Congratulations. You have just completed a full change of your systems three pre-filters ensuring the
purest of water for you and your family and the continued performance of your system.
R.O. Membrane – How to change the R.O. Membrane of your system.
The fourth stage of your system is the Reverse Osmosis Membrane (Dow Filmtech Material R.O.)
0.00001 Micron. For your convenience, the Reverse Osmosis Membrane offered by Aquasafe will fit
perfectly into any Reverse Osmosis System Aquasafe has offered in the past, currently does offer or will
offer in the future.
Step 1. Depressurize your system. (see Fig. 23)
Step 2. Remove R.O. Membrane housing Cap (Fig. 27)
1
Remove white tubing (see Fig. 10) from
Figure 27
the elbow adaptor found on the cap of
the Reverse Osmosis Membrane Housing.
Removing the
R.O. Membrane
Housing cap
to tank
E-Z Flush
Flow Restrictor
After the 10-15 minute ush turn Manual Shut-O
Valve back OFF and reconnect the white and
yellow tubes to their original positions.
to faucet
www.aquasafecanada.com
www.aquasafecanada.com | Home II Installation Instructions 05/13 | page 19
2 Connect the yellow tubing to the last
pre- lter housing. The ush water will run
through this tube into your drain.
yellow tubing
to discharge
saddle clamp
feed water in
Manual
Shut-O Valve
in "OFF" position
5
If this is the only lter change you are doing at this
time, you can turn the Manual Shut-O Valve and Tank
Top Valve back ON and you are
disconnected
elbow
white tube
NOTE:
Side View
DONE!
2
Using the small
canister wrench that
Small Canister
came with your system,
Wrench
remove the cap of the
R.O. Membrane
to tank
housing. Twist the cap
counter clockwise.
Please note: Have a
cloth at hand... some
water will come out
when taking the cap
o the R.O. Membrane
housing and removing
the membrane itself.
yellow tubing
to discharge
saddle clamp
feed water in
Turn Manual
3
Shut-O Valve
back ON and ush
new pre- lters for
10-15 minutes