Barometric Pressure - Clas Ohlson WH-1080 User Manual

Barometric pressure

1. Press the section for barometric pressure and use the [ + ] and [ – ] buttons to
choose absolute barometric pressure (the actual barometric pressure regardless
of altitude) or relative barometric pressure (calculated from a combination of values
for absolute barometric pressure and altitude).
2. Press again in the same section. Use the [ + ] and [ – ] buttons to change the units
between hPa, inHg and mmHg.
3. Press the same section a third time in order to adjust the settings for relative
barometric pressure. Adjust the values using the [ + ] and [ – ] buttons.
4. Press the same section a fourth time in order to set the alarm to sound for high
barometric pressure. HI AL is shown on the display. Change the values with
the [ + ] and [ – ] buttons or turn off the alarm with the [ ON/OFF ] button.
When the alarm is activated, the speaker icon is shown on the display.
5. Press the section for a fifth time and set the alarm to sound for low barometric
pressure in the same way as the alarm was set for high barometric pressure.
"LO AL" is shown on the display.
6. Press the same section for a sixth time in order to display the highest measured
barometric pressure. "MAX" is shown on the display. Delete the value by pressing
it on the display and holding it for 3 seconds.
7. Press the same section for a seventh time in order to display the lowest measured
barometric pressure. "MIN" is shown on the display. Delete the value by pressing it
on the display and holding it for 3 seconds.
8. An eighth press returns the device to normal mode.
9. Barometric pressure history:
Press once on the pressure history diagram and then use the [ + ] and [ – ] buttons
to change the display of information from 12 hours to 24 hours.
10. Press the diagram again to return to normal mode.
Clock
1. Press the clock once. Use the [ + ] and [ – ] buttons in order to set the contrast
level from 0 to 8 (5 is preset).
2. Press the clock display again. Use the [ + ] and [ – ] buttons to set the time zone.
3. Press the clock again and use the [ + ] and [ – ] buttons to set the clock's display
for a 12 or 24 hour time display.
4. Press the clock a fourth time, causing the hours display to flash. Adjust the hours
using the [ + ] and [ – ] buttons.
5. Press the clock a fifth time, causing the minutes display to flash. Adjust the minutes
using the [ + ] and [ – ] buttons.
6. Press the clock once again to confirm.
Date
1. Press the date once. Use the [ + ] and [ – ] buttons to shift between displaying
the alarm time, date or weekday.
2. Press the date display again. Press the [ + ] and [ – ] buttons in order to change
the date format DD-MM or MM-DD (the display shows "dM" or "Md" depending
on which format is chosen).
3. Press the date display a third time causing the year display to flash.
Change the year value by using the [ + ] and [ – ] buttons.
4. Press the date a fourth time causing the month display to flash.
Change the month value by using the [ + ] and [ – ] buttons.
5. Press the date display a fifth time causing the date display to flash.
Adjust the date using the [ + ] and [ – ] buttons.
6. Press the date display a sixth time causing the alarm display to flash.
Set the alarm time hours with the [ + ] and [ – ] buttons.
7. Press the date a seventh time. Set the alarm time minutes with the [ + ] and [ – ] buttons.
8. Then press [ ON/OFF ] to turn the alarm on or off. When the alarm is activated,
the speaker icon is shown on the display.
9. Press once more to confirm your settings.
9