Wind Speed; Weather Forecast - Clas Ohlson WH-1080 User Manual

3. Press the same section for a third time in order to display the highest
measured humidity. "MAX" is shown on the display. Delete the value by
pressing it on the display and holding it for 3 seconds.
4. Press the same section for a fourth time in order to display the lowest
measured humidity. "MIN" is shown on the display. Delete the value by
pressing it on the display and holding it for 3 seconds.
5. A fifth press returns the device to normal mode.

Wind Speed

1. Press the section for wind speed. Select the average wind speed or highest
measured wind speed (Gust) by pressing the [ + ] or [ – ] buttons.
2. Press the same section again. Use [ + ] or [ – ] to select the display in km/h,
mph, m/s, knots or Bft.
3. Press the same section a third time in order to set the alarm to sound for
high wind speeds. "HI AL" is shown on the display. Change the values with
the [ + ] and [ – ] buttons or turn off the alarm with the [ ON/OFF ] button.
When the alarm is activated, the speaker icon is shown on the display.
4. Press the same section a fourth time in order to set the alarm to sound for
wind direction. Wind direction flashes in the display Use the [ + ] and [ – ]
buttons to set the alarm to sound for the wind direction of your choosing.
Turn off the alarm with the [ ON/OFF ] button. When the alarm is activated,
the speaker icon is shown on the display.
5. Press the same section for a fifth time in order to display the highest
measured wind speed. "MAX" is shown on the display. Delete the value by
pressing it on the display and holding it for 3 seconds.
6. A sixth press returns the device to normal mode.
Rain
1. Press the display's rain gauge once. Use [ + ] or [ – ] to select the display of
the amount of rainfall every hour, 24 hours, week, month or total overall rainfall.
2. Press the rain gauge again and then [ + ] or [ – ] to display rainfall amounts in
mm or inches.
3. Press the same section a third time in order to set the alarm to sound for
high rainfall amounts. "HI AL" is shown on the display. Change the values
with the [ + ] and [ – ] buttons or turn off the alarm with the [ ON/OFF ]
button. When the alarm is activated, the speaker icon is shown on
the display.
4. Press the same section for a fourth time in order to display the highest
measured rainfall. "MAX" is shown on the display. Delete the value by
pressing it on the display and holding it for 3 seconds.
5. Press a fifth time on the section and CLEAR will begin to flash at
the bottom of the display. Press and hold in the section for 3 seconds.
The rain gauge settings for hour, 24 hours, week, month, and total rainfall
amounts are reset/cleared.

Weather forecast

1. Press once in the weather forecast section. Change the display from sunny,
partly cloudy, cloudy and rainy using the [ + ] and [ – ] buttons.
2. Press once more in the same section. Use the [ + ] and [ – ] buttons to
change the threshold value of the barometric air pressure from 2-4 hPa
(preset at 2 hPa).
3. Press a third time in the section and use the [ + ] and [ – ] buttons to set
the threshold value for storms from 3-9 hPa (preset at 4 hPa).
4. Press a fourth time to return to normal display mode.
8