Hardware Setup - SMC Networks SMC7004ABR Quick Installation Manual

Hardware Setup

SMC7004ABR – Front Panel
SMC7008ABR – Front Panel
1. Connecting Computers: Connect computers directly to the Barricade on ports 1-4/8 on the
front panel. If you have more than 4/8 computers to plug in, connect a hub or a switch (using
its uplink port) and connect additional computers to that device.
2. Connecting a Cable Modem or DSL Modem: Connect your Cable or DSL modem to the
WAN port on the rear panel.
3. Connecting a Dial-up Modem: If you use an external dial-up modem or ISDN modem,
connect it to the COM port on the rear panel.
4. Connecting a Printer: If you have a printer that you want to share between computers,
connect it to the Printer port using a standard parallel printer cable.
5. Power: Plug the power cord into the power jack.
SMC7004ABR – Rear Panel
SMC7008ABR – Rear Panel
Page 2