Setting Oven Controls - Kenmore 790.3670 series Use & Care Manual

Setting Oven Controls

Setting the Clock
The CLOCK pad is used to set the clock. The clock may be set for 12 or 24 hour
C
LOCK
time of day operation. The clock has been preset at the factory for the 12 hour
operation. When the range is first plugged in, or when the power supply to the range
has been interrupted, the timer in the display will flash with "PF" (power failure, See
Figure 1).
When PF appears in the display, press
a beep will sounds and PF will disappear.
INSTRUCTIONS
To set the clock (example: 1:30)
1. Press . "CLO" will appear in the display (Figure 2).
C
LOCK
2. Press
(Figure 3). "CLO" will stay in the display. Press
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold
C
LOCK
holding the pad until "12Hr" (Figure 4) or "24Hr" (Figure 5)
appears in the display.
F
LEX
2. Press to switch between the 12 and 24 hour time of day
C
LEAN
display. The display will show either "12Hr" (Figure 4) or "24Hr"
(Figure 5).
3. Press S to accept the desired change or press
TART
reject the change.
4. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
S
TOP
No sound will be heard, but after 10 seconds
.
C
LEAR
pads to set the time of day to 1:30
for 7 seconds (Figure 3). CONTINUE
PRESS
S
. "CLO"
TART
for 7 seconds
S
TOP
to
C
LEAR
S
TART
17
C
LOCK
S
TART
C
LOCK
F
LEX
C
LEAN
S
TOP
or
C
LEAR
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5