Installation; Location; Free Space Requirements; Cleaning Before Use - Matsui M142CF15E Instruction Manual

Installation

INSTALLATION

Location

When selecting a position for your unit you should make sure the floor is flat and firm
and the room is well ventilated. This unit can be used in a garage or outbuilding. For
optimum energy efficiency the unit should be located within an average room temperature
of between 10°C and 43°C. If the room temperature drops below or rises above these
temperatures the energy consumption and performance may be affected. Avoid locating
your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it
may increase the electrical consumption. Do not drape the unit with any covering.

Free Space Requirements

When installing the unit, ensure that 25 mm of
free space is left at both sides and 50 mm at the
rear of the unit. Please ensure there is adequate
space for the door to fully open at the top.

Cleaning Before Use

Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm
water using a sponge or cloth. Wipe completely dry. Clean the exterior of the unit with a
damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the
unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time
to settle.

Before Using Your Unit

Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it time to fall to the correct temperature. Your unit should not
be overfilled.
GB
15