Adjusting The Device - ABB M22001 series Manual

ABB-Welcome
During settings, if the value set is beyond the wanted number, press
tens digit and units digit will go back to the default value 0.
4. Exit the programming mode
Hold this programmable button for 3 seconds until the blue LED & red LED flash
once simultaneously.
Pos : 67 /DinA4 - Anl eitungen Onli ne/Ueberschriften/2./Rei nigung @ 19\mod_1310733980533_15.doc x @ 107853 @ 2 @ 1
Pos : 70 /DinA4 - Anl eitungen Onli ne/Ueberschriften/2./Geraeteei nstellungen @ 18\mod_1302768847744_15.doc x @ 103548 @ 2 @ 1
4.3

Adjusting the device

Pos : 71 /DinA4 - Anl eitungen Onli ne/Ueberschriften/3./Absc hlus s widerstand @ 19\mod_1321958079906_15.doc x @ 110083 @ 3 @ 1
Pos : 72 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Absc hl uss widerstand setzen 83220-AP- xxx @ 19\mod_1310723392369_15.doc x @ 107841 @ @ 1
Fig. 2:
Pos : 74 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Master/Sl ave Schalter s etz en 83220-AP- xxx @ 19\mod_1310723320966_15.doc x @ 107833 @ @
1. X100 X10 X1
Jumper to set the address of the indoor station.
EXAMPLE: setting address 024
2. Master /Slave function
Only one indoor station in each apartment must be set as "Master" (Jumper should
|
Operations
, both
— 9 —