Adjusting The Device; Terminal Resistor - ABB Welcome M2233 Series Manual

®
ABB Welcome
4.4

Adjusting the device

4.4.1

Terminal resistor

Fig. 35: Terminal resistor
No. Functions
1 Station
Select switch to set the address of the default outdoor station.
2 X10 X1
Select switches to set the address (0-99) of the indoor station.
For setting addresses that range into the hundreds,
see Chapter 4.2.12.15, setup.
3 Master or slave function
Only one indoor station in each apartment should be set as the "master."
(Switch should be set as "M/S on.") All additional indoor stations in the
same apartment must be set as "slave." (Switch should be set as "M/S off.")
4 Terminal resistor
In video installations or mixed audio and video installations, the switch
should be set as "RC on" on the last device of the line.
— 44 —