Table of Contents
Advertisement
servo arm on the servo and install the servo in the wing using 2.9 x 13mm sheet metal screws.
Using the M3 x 135mm threaded rod supplied screw on 2 x M3 nuts (one at each end) and then screw
on the supplied aluminium ball link. Install the pushrod open end through the back of the wing and screw
in to the aluminium clevis on the servo arm. It is recommended to add a length of brass or carbon tube to
further strengthen the pushrod. Once happy with the flap throws tighten the nut at each end of the
pushrod.
Fig. 42
Undercarriage
Main Gear Doors
The undercarriage set available for the BAE Hawk is
specifically designed for this model and fits straight on
to the mounting rails fitted in the wings and fuselage.
The legs are supplied in plain aluminium finish for you
to fit as is or paint according to the colour scheme of
your model.
The main gear legs are supplied with a set of fibreglass
covers. These are not necessary for operation but
greatly enhance the scale looks of the model. The front
gear doors are fully fitted for you at the factory and the
main gear doors simply attach to the pre fitted and
drilled mounting points inside the fuselage.
Fitting the main gear door rams simply requires you to
drill the gear door ram mounting posts Ø4mm and
attach the door rams with the supplied M4 x 20mm
18
Skygate Collection
BAE Hawk Mk 66
Fig. 43
Fig. 44
Fig. 45
Advertisement
Table of Contents
