Call Acknowledgement; Making A 5-Tone Group Call - Tait t2020 User Manual

Making a
5-Tone Group
Call

Call Acknowledgement

After you have made a 5-tone call, you may hear an
acknowledgement tone, beep, or series of tones
from your radio, indicating that your call has been
received. If you do not hear a tone, either:
I the called radio is incapable of generating an
acknowledgement, or
I the called radio is turned off, or
I the called radio is out of range of your call.
Your radio may also be programmed to display the
status of the called radio:
Display Meaning
Reads
NO ACK No acknowledgement sequence from the
called radio was detected.
NO STAT An acknowledgement sequence was detected
but no status information was decoded.
a status An acknowledgement sequence was detected
message e.g. and the decoded status number can be identi-
AT LUNCH fied.
a status An acknowledgement sequence was detected
number e.g. but the decoded status number cannot be
21 identified.
Note: If any control head activity is
detected before any of the above messages
are displayed, the acknowledgement
sequence is no longer expected, and any acknowl-
edgement messages received will no longer be dis-
played.
Your radio may be programmed so that you can
make 5-tone calls to a group of radios. When a
group call is sent, there is no acknowledgement
tone from any of the other users.
5-Tone Signaling 21