Ip Address Limiting Ipv4 / Ipv6; Ipsec Setting; Ipsec Setting (Ext. Ctrl.) - Riso 9150 Administrator's Manual

IP Address Limiting IPv4 / IPv6

Specify computers that can access the machine.
<Description of settings>
• IP address
• Subnet mask (when IPv4 is in use)
• Prefix length (when IPv6 is in use)
1 Press [IP address limiting (IPv4)/
(IPv6)] on the [Admin. Settings]
screen.
2 Select [Limited] and enter an IP
address and a subnet mask or a
prefix length of the computer to
which access will be granted.
38
● When granting access to a specified computer
Specify the subnet mask of 255.255.255.255
for the IP address of the specified computer.
● When granting access to multiple computers
Specify the subnet mask of 255.255.255.0 for
the IP address of each computer.
Example: When the IP address is set to
"192.168.0.100", a computer with an IP address
within the range from "192.168.0. 0" to
"192.168.0. 255" will be able to access the
machine. The ones with the other addresses will
not.
3 Press [OK].
You can configure this function in the RISO
Console. (See p. 11)

IPsec Setting

Configure this setting to use data encryption
technology (IPsec) to prevent data leaks and
fabrication in a network environment and
strengthen security.
In the [IPsec setting], [Security policy] settings
vary depending on your network environment.
<Description of settings>
• IPsec setting
OFF, ON
• Security policy
You can register up to 10 details of security policy.
Press the [Basic], [IKE] and [Comm.] tabs, and
configure the details of each function. The [Basic]
tab has settings of both IPv4 and IPv6.
Press [IPsec setting] on the
1
[Admin. Settings] screen.
ComColor Series Administrator's Guide 06