3Com 3CRWEASYA73 / WL-575 User Manual page 252

C 6: C L
HAPTER OMMAND INE
Example
AP(if-wireless a)#bridge role root-bridge
AP(if-wireless a)#
bridge channel-auto-sync
CAUTION: Do not enable Channel Auto Sync on a master bridge if there is no
!
root bridge acting as the master bridge's parent.
This command allows a child bridge to automatically find the operating channel
of its parent bridge.
Syntax
Default Setting
Command Mode
Example
AP(if-wireless a)#bridge channel-auto-sync enable
Enable channel auto sync!!
AP(if-wireless a)#
I
NTERFACE
When the access point is operating in this mode, traffic is not forwarded
to the Ethernet port from the radio interface.
• Up to six WDS bridge links (MAC addresses) per radio interface can be
specified for each unit in the wireless bridge network. One unit only must
be configured as the "root bridge" in the wireless network. The root
bridge is the unit connected to the main core of the wired LAN. Other
bridges need to specify one "Parent" link to the root bridge or to a bridge
connected to the root bridge. The other five WDS links are available as
"Child" links to other bridges.
• The bridge link on the radio interface always uses the default VAP
interface, VAP1. In Bridge or Root Bridge mode, VAP interfaces 2 to 4 are
not available for use. In Repeater mode, VAP interfaces 2 to 4 can still be
used to provide an access point service.
bridge channel-auto-sync <enable | disable>
• enable - The bridge will automatically search and find the operating
channel of its parent.
• disable - The bridge must have the operating channel manually set to the
operating channel of its parent bridge.
Disabled
Interface Configuration (Wireless)
6-120