Installation Guide; Anti-Theft System - Hyundai CRM 129 SU Instruction Manual

INSTALLATION GUIDE

Installation Opening
This unit can be installed in any dashboard
having an opening as shown below.
The dashboard should be 4.75 mm – 5.56 mm
thick in order to be able to support the unit.
If the opening is too small, carefully cut or file
as necessary until the sleeve easily slides into
the opening. Do not force the sleeve into the
opening or cause it to bend or bow. Check for
sufficient space behind the dashboard for the
unit chassis.
Reset
Press the RESET button with a pointed object
to reset the unit to the original status.
Note: Press the RESET button will erase the
clock setting and stored stations.
Installation Procedures
1) If relevant, remove any other audio system
from the car.
2) Insert the mounting sleeve into the dash-
board. Fix it firmly in place by folding down
the metal tabs.
3) Perform the required electrical connections.
4) Then check that everything works before
installing the main unit.
5) Remove the two screws on the top of the
unit, otherwise, the unit will not work.
6) Install the car radio in the dashboard using
the supplied screws (M5 x 6mm).
7) Attach the outer trim frame.
CAUTIONS:
Assembly is necessary to do in the service
center.
The car radio must not be installed in the ex-
cluded zone of head impact!
R ESET
Mounting bolt
Rubber cushion
Remove the
two screws
Trim plate

ANTI-THEFT SYSTEM

This unit is equipped with a detachable panel.
Removing this panel makes the radio totally
inoperable.
Remove the detachable panel
1) Press button.
2) Hold the part
popped out and pull
the panel out.
3) Gently press the
button of the case
and open the cover.
Place the panel into
the case and take it
with you when you
leave the car.
Install detachable panel
1) Fix right part of face
plate in the panel
slot of the unit.
3) Press down the
left side of the face
plate until it clicks
into the panel slot.
Remove the unit
1) Switch off the power of the unit.
2) Remove the panel
and the trim plate.
3) Insert both L-Keys
into the hole on the
front of the set until
they lock.
4) Pull out the unit.
EN - 46
Mounting sleeve
Main unit
1
2
2
1