Control Throws; Flight Preparation - Seagull Models GLASAIR SPORTSMAN 2-2 Assembly Manual

With the wing attached to the fuselage, all
parts of the model installed ( ready to fly), and
empty fuel tanks, hold the model at the marked
balance point with the stabilizer level.
Lift the model. If the tail drops when you lift,
the model is "tail heavy" and you must add
weight* to the nose. If the nose drops, it is
"nose heavy" and you must add weight* to the
tail to balance.
*If possible, first attempt to balance the model
by changing the position of the receiver battery
and receiver. If you are unable to obtain good
balance by doing so, then it will be necessary
to add weight to the nose or tail to achieve the
proper balance point.
60mm.

CONTROL THROWS.

Ailerons: 12mm - 15mm up
12mm - 15mm down.
Elevator: 12mm - 15mm up.
12mm - 15mm down.
Rudder: 20mm - 30mm left.
20mm - 30mm right.
www.seagullmodels.com
elevator, rudder, ailerons and throttle.
manufacturer's instructions and turn every-
thing on.
on the elevator stick. The elevator halves
should move up. If it they do not, flip the servo
reversing switch on your transmitter to change
the direction.
behind the airplane, move the rudder stick to
the right. The rudder should move to the right.
If it does not, flip the servo reversing switch on
your transmitter to change the direction.
throttle stick forward should open the carbu-
retor barrel. If it does not, flip the servo re-
versing switch on your transmitter to change
the direction.

FLIGHT PREPARATION.

Check the operation and direction of the
A) Plug in your radio system per the
B) Check the elevator first. Pull back
C) Check the rudder. Looking from
D) Check the throttle. Moving the
E) From behind the airplane, look at
the aileron on the right wing half. Move the
aileron stick to the right. The right aileron
should move up and the other aileron should
move down. If it does not, flip the servo re-
versing switch on your transmitter to change
the direction.
31