Table of Contents
Advertisement
Step Six: Connect to the Cellular Network
This section describes how to set up the Cellular Router to initiate a wireless
WAN connection.
There are 2 different ways to set up a wireless WAN connection via PPP:
Initiating the PPP Connection directly from the Cellular Router acting
as the PPP Client (most common).
Initiating the PPP Connection from a different PPP client (i.e. laptop
or router) with the Router running in transparent PPPoE mode. This
method is not documented in this quick start guide.
Initiating a PPP Connection from the Cellular Router
The status page of Cellular Router Setup will now be displayed as below.
The PPP status on the page should be DISABLED network (as indicated by
the large arrow) as your new device is not yet configured to connect to the
cellular network.
Click the Internet Settings > WWAN (3G) link on top panel of the screen to
open the Connection web page.
14
NTC-40 Series Quick Start Guide
Advertisement
Table of Contents
