Hc (Hardware Configuration) - NEC NX7700i/5080H-32 Operation Manual

Base Module
2.4.6.7.

HC (Hardware Configuration)

m
X
* For system states and subcommand validity, read the description of subcommands.
Function:
This command is used to show the hardware configuration and enable to change it.
It is also used to configure, show, or change partitions.
In a duplicated iSP environment, the hardware configuration is automatically matched between
the duplicated iSPs.
Description of Subcommands
cmd
help -
quit -
exit
disp -
all
part
main
exp
cellx
855-900547-200
b u
arg1 arg2 arg3
- -
- -
- -
- -
- -
- -
- -
- -
arg4
- Show a list of subcommands.
This subcommand is always valid without
regard to the current system state.
- Quit the HC command.
Before the HC command quits, the check
subcommand is automatically run.
These subcommands are always valid
without regard to the current system state.
- Show the system's hardware configuration.
If no argument is specified or has an error,
the disp subcommand help opens.
This subcommand is always valid without
regard to the current system state.
- Argument "all" shows all the configuration
information.
- Show the current partitioning.
The following information is given for each
partition:
State summary
Physical CELL No. and logical CELL No.
Physical IOX No. and logical IOX No.
Size of shared memory (ISPF only)
- Show the Main Cabinet or Main Chassis
configuration.
For the 8Way/ISPF model, the configurations
of external PCI Bay and Power Bay are also
shown.
- Valid only for the 32Way model.
Use this argument to show the expansion
cabinet configuration.
- Show the CELL configuration.
X denotes a physical CELL number (0-7).
2-48
Description