NEC NX7700i/5080H-32 Operation Manual page 94

Base Module
cmd
clkx
xbxcx
cellx
pcibx
pcix0y
frn
ffn
loc -
main
pbayx
855-900547-200
arg1 arg2 arg3
on|off -
on|off -
on|off -
on|off -
on|off -
on|off -
- -
d
d h
arg4
- Turn On/Off the LED on the CLK Card.
x is a CLK Card number (0-1).
- Turn On/Off the LED on the XBX Card.
x is a XBX Card number (0-3).
- Turn On/Off the LED on the CELL Card.
x is a physical CELL number (0-7).
- Turn On/Off the LED on the PCI Bay.
x is a PCI Bay number (0-7).
- Turn On/Off the LEDs on the PCI Bay's PXH
PCI slots by specifying the slot numbers
printed on the back of the box.
x is a PCI Bay number (0-7).
y is a slot number (PXH slot number (1-8)
printed on the back of the box).
- Turn On/Off the Fan-Box LEDs by specifying
their locations.
Argument frn specifies the rear-side
Fan-Box, and ffn the front-side Fan-Box.
- This command is supported on the 8Way
and ISPF models.
Use this command to manually specify
devices' location information.
If no argument is specified or an argument
has an error, the loc command help opens.
This command is valid only if all the
partitions are inactive.
This command is supported on the 8Way
and ISPF models.
It sets the vertical position of the main
chassis within the cabinet.
Argument d specifies the position (U) of the
bottom of the main chassis with a decimal
number (0-40).
The default value is null (0).
- Set the vertical position and height of Power
Bay No.1 that is installed outside the main
chassis of the 8Way model.
x is only valid if it specifies Power Bay No.1.
Argument d specifies the position (U) of the
bottom of the unit with a decimal number
(0-40).
Argument h specifies the height of the unit
(2).
This command is not supported on the
32Way, ISPF, or Power Bay No. 0 for the
8Way model as the Power Bay position and
height are uniquely determined on those
models.
2-58
Description