Table of Contents
Advertisement
Base Module
Category
Hot Plug
permission
SP LAN/Serial Port Setting:
Category
Serial port
LAN0
LAN1
[ISPF only]
NTP server
System number
[ISPF only]
Cabinet
clustering (*3)
[ISPF only]
Cabinet-clustered
LAN0/1 (*3)
[ISPF only]
(*3): If any of these configuration parameters has been changed, reset the SP in ISPF System
2.
855-900547-200
[Hot Plug permission]
Specifies whether Hot-Plug is enabled or not, for
each of the target components.
Target components: CELL, PCIDBAY, PCIEBAY,
PCI(X) card, and PCI-Ex card
The 8Way model has no PCIDBAY or PCIEBAY
settings.
The 32Way(H) and ISPF require PCI(X) card and
PCI-Ex card settings.
The following parameter settings are needed
depending on the other device (terminal
emulator) to which the SP is connected as a
local console.
Baud rate
Data bit width is only listed.
It is unable to be changed.
Stop bit width is only listed.
It is unable to be changed.
Parity is only listed.
It is unable to be changed.
Flow control is only listed.
It is unable to be changed.
IP address for LAN0
Subnet mask
Gateway IP address
IP address for LAN1. LAN1's subnet must be
different from LAN0's subnet.
Subnet mask
Gateway IP address
NTP server's IP address.
If the server IP address is set, iSP's internal
clock is corrected every 1 hour.
If the IP address is omitted, the iSP clocks on its
own.
[Self SYSTEM NUMBER]
System number (0 or 1).
(*3)
It is used as part of cabinet location numbers.
Different system numbers must be set for the 2
cabinets that constitute a cluster.
Specifies whether cabinet clustering is used or
not.
For cabinet clustering, the other iSP's IP
SP
address is specified. LAN1's subnet must be
different from LAN0's subnet.
Configuration Parameter
Configuration Parameter
2-80
Default Setting
off
Default Setting
-
9600
8
1
None
RTS/CTS
192.168.119.100
or
192.168.119.101
255.255.255.0
N/A
192.168.119.200
255.255.255.0
N/A
N/A
0
no
LAN0:
192.168.119.110
LAN1:
192.168.119.210
Advertisement
Table of Contents
