Mounting IP-PAD Card
Page 18
IP-PAD
Card
No. 0
Note Note
IP-PAD
IP-PAD
Card
No. 2
Note Note
IP-PAD
This slot must be vacant except for the VCT card.
Note:
For the IP-PAD card, the card number must be assigned by the system data
programming according to the PIM and slot, which accommodates the card.
3. After mounting the card, set the MB switch to DOWN position to put the card in
service.
PIM 0/2/4/6
IP-PAD
Card
No. 1
Note Note
IP-PAD
PIM 1/3/5/7
IP-PAD
Card
No. 3
Note Note
IP-PAD
Figure 2-9
Mounting IP-PAD Card
Chapter 2 System Configuration
L/T must not
be mounted
L/T must not
be mounted
NEAX 2000 IPS Configuration Guide
NDA-24347, Issue 1