Insert Tools, Accessories - Hilti SFH 14-A Operating Instructions Manual

Hide thumbs Also See for SFH 14-A:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ancillary equipment may present hazards when used incorrectly
by untrained personnel or when used not as directed.
The working environment may be as follows: construction site,
workshop, renovation, conversion or new construction.
2.2 Chuck
Keyless chuck
2.3 Switches
Control switch with electronic speed control
3-speed gear selector
Forward / reverse selector switch with transport lock
Setting ring for torque, drilling and hammer drilling
2.4 Grips
Pivotable side handle
Vibration-absorbing grip
2.5 Lubrication
Grease lubrication
2.6 The items supplied include (toolbox versions):
1 Power tool
1 Side handle
1 Operating instructions
1 Hilti toolbox
2.7 The items supplied include (cardboard box versions):
1 Power tool
1 Side handle
1 Operating instructions
2.8 Additional items required for operating the tool
B 14/3.3 Li­Ion battery with C4⁄36­90, C4⁄36­350, C 4/36,
C 4/36­ACS or C 4/36­ACS TPS charger.
2.9 Li-ion battery charge status and overheating indicator
LED 1 blinks when the battery charge level is too low. In this case,
remove the discharged battery and insert a charged battery.
LEDs light con-
stantly
LED 1,2,3,4
LED 1,2,3
LED 1,2
LED 1
-
-
2.10 Power tool overloading and overheating indicator
The power tool is equipped with an electronic protection system
to prevent overloading and overheating. The power tool switches
itself off automatically in the event of overloading and overheating.
After releasing the control switch, the power tool may not restart
immediately when the switch is pressed again (while the power
tool is cooling down).
LEDs light constantly
-

3 Insert tools, accessories

Designation
Bit holder
Charger for Li-ion batteries
Printed: 26.08.2013 | Doc-Nr: PUB / 5152169 / 000 / 01
LEDs blink
-
-
-
-
LED 1
LED 1
LEDs blink
LED 1,2,3,4
Short designation
S-BH 50
C 4/36
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
Battery overheated
Power tool
status
Power tool over-
loaded or over-
heated
en
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sf 14-a

Table of Contents