Advertisement
Marking between
"Lever" and "Push"
start selection SW.
L ←→ P
See page 4, how to
do it.
Switch lever
(Driver rotates on press-
ing the switch lever)
Torque adjust-
ment scale
Accessories
● Bits
● Torque adjustment spring
There are 2 torque adjusting springs for BLG-4000.
In the BLG-4000, stronger spring (Red) is installed.
If you want to use weaker spring then replace with
accessory (White) spring.
Select the sprig depends on your fastening torque.
● Hex nut L wrenches (for BLG-5000, BC1, OPC)
BLG-5000
Selectable by the Switch.
Hanger
Bit
(HIOS shank)
( Lever or Push Start)
Driver cord plug
The shapes of both plugs
are the same (5P)
BC1, OPC cord plug (6P)
Driver
connector
Joint shaft collar
- 2 -
FOR/REV switch
FOR: Forward
OFF: Neutral
REV: Reverse
Advertisement
