SunStar KM-2070P SERIES User Manual page 18

■ Changing stitch number and width of end condense.
Sewing type of end condense.
■ Operation Order
1. Press and condense key on condition that power is on.
Indication lamp of end condense turns on and C side stitch
number of end condense is displayed on the indication
device.
2. Change the number of stitch by using + and - key.
(Ex : 10 stitches )
3. Press end condense key once again.
D side stitch number of end condense is displayed on the
indication device.
4. Change the number of stitch by using + and - key.
(Ex : 10 stitches )
5. Press end condense key once again.
Width U is displayed on the indication device.
6. Press PARA/SET key to change width of end condense.
Indication PARA/SET lamp turn on and indication device
blinks at the same time.
7. Change the width by using + and - key. (Ex : 3 mm )
8. Set the changed value by pressing PARA/SET key.
Width is displayed on the indication device
9. Press zigzag-width key.
zigzag width is displayed on the indication device
10. Start sewing by pedaling forward.
11. Execute thread trimming by pedaling back when the sewing
is completed, then end condense executed before thread
trimming.
<Note>
C , D side stitch number of start condense : 0~99 [stitch]
width of start condense : 0~8.0 [mm]
<Note>
Start speed of end condense is 1200spm (in case of sew-
speed is above 1200spm) and execute the set sew-speed in
case of sew-speed is below 1200 spm.
18
status of sewing
C
D
end condense, width
Power On Status
[indication device]
number of end condense
or
number of end condense
or
end condense
Chang width
or
end condense stitch number
(C side)
end condense stitch number
(D side)
C side stitch
D side stitch
Width of