Using Method Of End Condense - SunStar KM-2070P SERIES User Manual

9) Using Method of End Condense

Ex) It is the example of pattern 3 with ZigZag-width of 6mm.
■ Indication Status of Operation Panel
■ Operation Order
1. Press end condense key on condition that power is on.
Indication lamp of end condense turns on and C side stitch
number of end condense is displayed on the indication
device.
C side stitch number scope : 0~99 [stitch]
2. Press end condense key once again.
D side stitch number of end condense is displayed on the
indication device.
D side stitch number scope : 0~99 [stitch]
3. Press end condense key once again, then width of end
condense in displayed on the indication device.
width scope : 0~8.0 [mm]
4. Press zigzag-width key.
Zigzag-width is displayed on the indication device.
5. Start sewing by pedaling forward.
6. Execute thread trimming by pedaling back when the sewing
is completed.
Then end condense executed before thread trimming.
<Note>
If you turn on the indication lamp of end condense by pressing end condense key, sewing is possible on that condition as well.
If you pressed end condense then uses to see the setting status of end condense.
Adjustment of stitch width (see "3_20" ) reverse button.
A, D side stitch width : setting to feed adjustment dial
B, C side stitch width : setting to condense adjustment dial
Power On Status
Indication Device
display C side stitch
number of end condense
display D side stitch
number of end condense
display width of
end condense
Sewing
R
17