Renkforce DAB-RCD3038 Operating Instructions Manual page 65

Operation
• Setting the RDS Parameters
To set the RDS parameters, press the PTY button (24) a little longer (>2 seconds) and then press it once more, but
only very briefly, until the desired function appears on the display.
Choose the options for the respective settings by turning the VOLUME control (4).
The following settings can be made:
TA SEEK/ALARM
TA SEEK: When the radio has lost the traffic information, it will seek a new station with Traffic Announcement
coding on its own.
TA ALARM: When the radio cannot receive the TA code anymore, there will be an alarm signal.
PI SOUND/MUTE
Device reaction when a transmission area is reached where 2 different stations with different programme
identification are transmitting the same AF (alternative frequency):
PI SOUND: The radio switches to the new station for a few seconds and then back.
PI MUTE: The new station is muted.
RETUNE L/S
RETUNE L: When the radio does not receive traffic announcements any more, the auto-scan starts 90 seconds
later.
RETUNE S: When the radio does not receive traffic announcements any more, the auto-scan starts 30 seconds
later.
MASK DPI/ALL
Device reaction during channel search:
MASK DPI: Alternative frequencies with different programme information (PI) are not considered.
MASK ALL: Alternative frequencies with different programme information (PI) and alternative frequencies with a
high signal strength but without RDS information are not considered.
65