Renkforce DAB-RCD3038 Operating Instructions Manual page 63

Operation
• AF button (9)
Press the AF button (9) once briefly
Press the button again
The AF button (9) activates the automatic transmitter station tracking.
"AF" will be displayed.
If the reception of an RDS transmitter station gets weaker or the radio does not receive and RDS station at all, the
display flashes.
When a station can be received well, the symbol is displayed continuously.
When you leave a transmission area, the radio can only switch to a better sender when the AF function is activated.
• TA button (10)
Press the TA button (10) once briefly
Press the button again
When you receive a traffic programme station, the display shows TP (traffic programme).
When you keep the TA button pressed, TA appears in the display as well.
If a different source is being played (e.g. SD playback), the programme is set to mute during the traffic announcement.
When you listen to a radio programme at a very low volume, the volume is automatically increased to an easily audible
level. When the traffic announcement is over, the volume you were hearing before is restored.

The minimum volume during traffic announcements can be adjusted by setting the RDS parameters
(see later in these instructions).
> AF is switched on
> AF is switched off
> TA is activated
> TA is deactivated
63