Table of Contents
Advertisement
Keypad Programming
S
E
2.1 Programming the Keypad
There are several programming options available for the LCD5501Z32-433 keypad.
These are described below. Record all your programming choices in the program-
ming worksheets included in this manual.
Programming the LCD5501Z32-433 is similar to programming the rest of the system.
When you are in the LCD5501Z32-433 programming sections, the keypad will display
which options are turned on along the top of the display. To turn an option on or off, press
the number corresponding to the option on the number pad. The numbers of the options
that are currently turned ON will be displayed.
For example, if options 1 and 2 are on, the display will look like this:
For information on programming the rest of your security system, please refer to your
system's Installation Manual .
2.2 Function Key Options
The function keys are programmed in sections [1] to [5]. By default, the 5 function keys
on the keypad are programmed as Stay Arm (03), Away Arm (04), Chime (06), Sensor
Reset (14) and Quick Exit (16). You can change the function of each key on every
keypad. Please see your system's Installation Manual for instructions on programming
the keys, and a complete list of all the function key options available for your system.
2.3 Clock Options
The LCD5501Z32-433 will display the current time after 30 seconds of no key
presses. To set the correct time and date for the system, please refer to your
system's Instruction Manual . You can change how the keypad displays the time with
the following options. To change the clock options:
1. Enter [*][8][Installer's code]
2. Enter [000] to go to keypad programming
3. Enter section [6] to go to clock options.
4. To turn any of the options on or off, press [1], [2], or [3]:
NOTE: If the Time does not display on keypad option is selected, make sure that the
Keypad displays time when zones are open option is also selected.
[1]
ON =
OFF = Time does not display on keypad
[2]
ON =
OFF = Clock display is in 24-hour format (e.g. 20:00)
[3]
ON =
OFF = Keypad displays time when zones are open
5. When you are finished programming the clock options, press [#] to exit.
C
T
Time displays on keypad
Clock display is in AM/PM format
(e.g. 08:00 AM)
Keypad does not display time when zones are open
I
O
5
N
2
- Quick Links:
- Section 7: Troubleshooting
Hide quick links:
Advertisement
Table of Contents
