Enroll & Program Wireless Keys - DSC LCD55O1Z32-433 Installation Manual

E N R O L L
5. The device is now enrolled on the system. Record the serial number and the
assigned zone number in the programming worksheets in the back of this manual.
6. Continue with steps 3 - 5 until you have enrolled all wireless devices.
7. To exit press [#].
NOTE: The devices will not work properly until you complete zone and partition pro-
gramming (see section 4).
3.3 Enroll & Program Wireless Keys (WLS909/WLS919)
For wireless keys to work on the system, you need to enroll them and then program the
function buttons. Wireless keys are not assigned to zones and require no zone
programming. You can enroll up to 16 wireless keys on the system.
Enroll Wireless keys
1. At a system keypad, enter [ ][8][Installer's code] to go to the Installer's Programming
section.
2. Enter programming section [804].
3. Enter a 2-digit number [41]-[56] to assign the wireless key a slot. These numbers
correspond to wireless key numbers 01-16.
4. Enter the key's ESN. The entry must be six digits. If an older key with a 5-digit ESN
is being enrolled, add the digit [0] to the beginning of the ESN. (E.g. ESN=61234,
enter 061234)
5. The key is now enrolled on the system. Record the serial number and the assigned
slot number in the programming worksheets in the back of this manual.
6. Repeat steps 3 - 5 until all wireless keys have been enrolled.
(PC5010, PC5020 and PC5015 only) (PC5010, PC5020 and PC5015 only)
7. (PC5010, PC5020 and PC5015 only) (PC5010, PC5020 and PC5015 only) (PC5010, PC5020 and PC5015 only) By default, all wireless keys are assigned to
Partition 1. To assign keys to Partition 2, enable the appropriate options in
programming sections [91] and [92].
NOTE: A wireless key can only be assigned to one partition.
8. To exit press [#].
Program the WLS909/WLS919 Function Buttons
WLS909 wireless keys have four programmable function buttons. You must program a
set of four functions for the buttons before any keys will work. After the functions are
programmed, when you press and hold one of the four buttons for two seconds, the
system will execute the programmed function.
For systems not using partitions: program the function buttons in section [59]. All
wireless keys will have the same four functions.
For systems using 2 partitions (PC5010, PC5020 and PC5015 only): all wireless keys
assigned to Partition 1 will have the four functions programmed in section [59]. All wireless
keys assigned to Partition 2 will have the four functions programmed in section [60]. For
example, if function button 1 in Section [59] is programmed for Stay arming, then pressing
the first button on wireless keys assigned to Partition 1 will Stay arm Partition 1.
NOTE: Wireless keys will not work when the partition they are assigned to is being
accessed for zone bypassing or programming.
& P R O G R A M
9
D E V I C E S