Decode Aiming Pattern; Aim Brightness - Motorola PL3307 Integration Manual

5 - 6 PL3307 Decoder Integration Guide

Decode Aiming Pattern

Parameter # F0h 32h
Select Enable Decode Aiming Pattern to project the aiming pattern during bar code capture, Disable
Decode Aiming Pattern to turn the aiming pattern off, or Enable Decode Aiming Pattern on PDF to project
the aiming pattern when the decoder detects a 2D bar code.
NOTE With
Aiming Pattern is disabled.
*
Enable Decode Aiming Pattern

Aim Brightness

Parameter # F1h 9Ch
This feature sets the brightness of the aim pattern. The default is 0, which indicates that the aim pattern is
always on in between camera exposures. For values above 0, each increment of the brightness value
increments the aim duration 0.5 ms.
To program Aim Brightness, scan this bar code followed by three numeric bar codes in
Bar Codes that correspond to the value representing brightness. Settings range from 0 to 255. The maximum
aim duration is limited by the frame time, so the recommended range is 0 to 30 when the frame rate is set to 60
fps.
Aim Brightness
Picklist Mode on page 4-19
(02h)
enabled, the decode aiming pattern flashes even when the Decode
Disable Decode Aiming Pattern
(00h)
Appendix D, Numeric