Power Mode (Serial Hosts Only); Time Delay To Low Power Mode - Motorola PL3307 Integration Manual

Power Mode (Serial Hosts Only)

Parameter # 80h
Select whether or not the decoder enters Low Power consumption mode after a decode attempt. In
Continuous On mode, the decoder does not enter this low power state.
Continuous On
(00h)

Time Delay to Low Power Mode

Parameter # 92h
This parameter sets the time the decoder remains active after decoding. After a scan session, the decoder
waits this amount of time before entering Low Power Mode.
NOTE This parameter only applies when Power Mode is set to Low.
To program a different value for this parameter than those provided here, see
Power Mode with SSI on page
*1 Second
(11h)
User Preferences & Miscellaneous Options 4 - 17
7-7.
*Low Power Mode
(01h)
Using Time Delay to Low
5 Seconds
(15h)