Picklist Mode; Decode Session Timeout - Motorola PL3307 Integration Manual

Picklist Mode

Parameter # F0h 92h
Picklist mode enables the decoder to decode only bar codes aligned under the center of the aiming pattern.
Select one of the following picklist modes:
•
Disabled Always - Picklist mode is always disabled.
•
Enabled Always - Picklist mode is always enabled.
NOTE With Picklist Mode enabled, the decode aiming pattern turns on even when the
page 5-6
*
Disabled Always
(00h)

Decode Session Timeout

Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout , scan the bar code below. Next, scan two numeric bar codes from
Appendix D, Numeric Bar Codes
numbers. For example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan
the 0 and 5 bar codes. To correct an error or change the selection, scan
Decode Session Timeout
is disabled.
that correspond to the desired on time. Provide a leading zero for single digit
User Preferences & Miscellaneous Options 4 - 19
Enabled Always
(02h)
Cancel on page
Decode Aiming Pattern on
D-2.