Fn1 Substitution Values - Motorola PL3307 Integration Manual

4 - 30 PL3307 Decoder Integration Guide
Scan Data Transmission Format (continued)
<PREFIX> <DATA> <SUFFIX 1>
<PREFIX> <DATA> <SUFFIX 1> <SUFFIX 2>

FN1 Substitution Values

Key Category Parameter # 67h
Decimal Value Parameter # 6Dh
The USB HID keyboard host supports a FN1 Substitution feature. Enabling this substitutes any FN1 character
(0x1b) in an EAN128 bar code with a value. This value defaults to 7013 (Enter key).
When using host commands to set the FN1 substitution value, set the key category parameter to 1, then set
the 3-digit keystroke value. See the ASCII character set table for the current host interface for the desired
value.
To select a FN1 substitution value via bar code menus:
Scan the bar code below.
1.
Locate the keystroke desired for FN1 substitution in the ASCII character set table in the appropriate host
2.
interface chapter. Enter the 4-digit ASCII value by scanning each digit in
To correct an error or change the selection, scan
See USB Keyboard FN 1 Substitution on page 6-13
(05h)
(07h)
Set FN1 Substitution Value
<PREFIX> <DATA> <SUFFIX 2>
Cancel on page D-2.
to enable FN1 substitution for the USB HID keyboard.
(06h)
Appendix D, Numeric Bar Codes.