To Record Annoucement Only Outgoing Message (Ogm2); To Play Back The Recorded Outgoing Messages - Sanyo CLT-D14 Instruction Manual

DIGITAL ANSWERING MACHINE
To record an Announcement Only outgoing
message (OGM2).
1. Slide the " Ringer " Switch at the bottom of the base unit to " ANN "
position.
2. Press and hold the
3. Speak the message for recording. The microphone is located at
the front of the base unit.
4. Press the
If the has not been pressed, the recording will automatically
be terminated when the recording time exceeds 2 minutes.
5. The recorded message will be automatically playback for
confirmation.
6. You can always record a new message to replace the recorded
message by repeating step 2 to 4 above.
Note: If memory is full (green LED flashes rapidly), you can't record
new OGM to replace the old OGM and error tone will be heard when
pressing and hold OGM button.
To playback of the recorded Outgoing Messages
Press the OGM button once, depending on the position of the Ring
switch at the bottom of the base unit, the respective Outgoing Message
will be playback. If the
at the base until a beep tone is heard.
once and beep sound will be heard for stop recording.
is pressed, the playback will be stopped.
25