Remote Access Operations - Sanyo CLT-D14 Instruction Manual

REMOTE ACCESS
2. If the answering machine has been switch ON, it will answer your
call according to the Ring Switch (at bottom of the base unit)
setting. The respective Outgoing message will be played. During
this Outgoing Message announcement period (and the 8 seconds
after the message), you can enter the remote access code. If the
remote access code is correct, you will hear a beep tone to indicate
the answering machine has entered the remote access mode.

Remote Access Operations

In the remote mode, there is 8 seconds waiting period for you to
enter a command, via the telephone's dialing keypad, for operation.
The following table lists the commands available for various
operations.
Key Digits
1 and then 1
1 and then 2
Commands
Playback all recorded messages (recorded
from telephone line or memo).
Playback the new messages (recorded from
telephone line or memo).
If there is no new message, a beep tone is
heard and then returns to remote access
mode.
30