Charging The Battery; Pairing The Oontz Angle 3 To Your Bluetooth Device - Oontz Angle 3 Manual

11. Micro USB Charging Port (under the black rubber flap) - This port is for used for charging the OontZ
Angle 3 battery only. You can use the included Micro USB cable connected to a laptop or PC; or you can use
an iPhone/Smartphone or tablet USB wall Power Adapter (not included) to charge your OontZ Angle 3

4) Charging the battery

The OontZ Angle 3 has a Lithium Ion rechargeable battery inside. To charge it, plug the micro connector end
of the USB cable into the Micro USB Charging Port (11).on the back of the OontZ Angle 3 and the other end
into a USB charging source. The source can be either from your desktop, laptop, or Smartphone USB wall
Power Adapter (not included). The Charging Indicator Light (7) on the top will flash red very slowly while
charging. When the OontZ Angle 3 battery is fully charged, the charging indicator light will be solid red. The
battery will take about 3 to 4 hours to fully charge.
Note 1. When the battery is low the red light will begin to flash, this indicates that the OontZ Angle 3
requires charging.
Note 2. You may use your OontZ Angle 3 while it is charging.
Note 3. It is recommended that you remove the charging cable after the OontZ Angle 3 is fully charged.
** When fully charged, the OontZ Angle 3 can play audio for up to 7 hours. This play time may vary for a
number of reasons including; the volume (louder volume results in shorter playtime), device, connection
(aux or Bluetooth), and music type.

5) Pairing the OontZ Angle 3 to your Bluetooth device

Make sure your OontZ Angle 3 has su cient charge or connect to a charging source. Pair and connect
wirelessly to your Bluetooth device by following these steps:
Step 1 – Turn on the speaker by pressing and releasing the ON/OFF Button (8). The Bluetooth Indicator
Light (2) on the side of the OontZ Angle 3 will flash blue. This indicates that the speaker is in pairing mode
and is ready to pair and connect to your device.
Step 2 – Enable the Bluetooth function on your device and then search/scan for the OontZ Angle 3. When
"OontZ Angle" appears on the Bluetooth device list, select it and your device will pair and connect to the
speaker. Make sure your device indicates that it is connected to "OontZ Angle" in your device list. If your
device requests a password, enter "0000".
Step 3 – The Bluetooth Indicator Light (2) will turn solid blue to indicate the OontZ Angle 3 is paired and