Description - Hilti TE 30 Operating Instructions Manual

Hide thumbs Also See for TE 30:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 20
Obligation signs
Wear eye
Wear a hard
protection
en
Wear
breathing
protection
Symbols
Read the
Equipped
operating
with theft
instructions
protection
before use
system
Double
Drilling
insulated
without
hammering
Hammer
Chiseling
drilling

2 Description

2.1 Use of the product as directed
The power tool is an electrically-powered rotary hammer with pneumatic hammering mechanism.
The power tools are designed for drilling in concrete and masonry. The power tool can also be used for light chiseling
work on masonry and surface finishing on concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Nationally applicable industrial safety regulations must be observed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
16
Wear ear
hat
protection
Lock symbol
1
Drilling
without
hammering,
1st gear
Chisel
position
adjustment
Location of identification data on the power tool
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Wear
protective
Type:
gloves
Generation: 01
Serial no.:
Return waste
material for
recycling.
2
Drilling
without
hammering,
2nd gear
Revolutions
per minute

Advertisement

Table of Contents
loading

This manual is also suitable for:

Te 30-avrTe 30-m-avrTe 30-c-avr

Table of Contents