Side Handle; Is A Risk Of Explosion As Per; Te Md20 Ls T Ha / Te Md20 Ls T Im; Description - Hilti TEMD20 LS T Operating Instructions Manual

Obligation signs
Wear eye Wear a Wear ear
protection safety protection
helmet
Symbols
Read the
operating
instructions
before use
These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cov-
er pages. Keep these pages open while studying the oper-
ating instructions.
In these operating instructions, the designation "the tool"
always refers to the TE MD20 LS T rotary hammer drill.
If the tool is used in areas where there is risk of explo-
sion, the information printed on a grey background in
these operating instructions must be observed. No
changes or modifications may be made to the tool with-
out consent from the approval authority.
Location of identification data on the tool
The type designation and serial number can be found on
the type plate on the tool. Make a note of this data in your
operating instructions and always refer to it when mak-
ing an enquiry to your Hilti representative or service
department.
Type:
Serial no.:
16
Printed: 08.07.2013 | Doc-Nr: PUB / 5071845 / 000 / 01

2. Description

The tool is a water-cooled, electrically-powered rotary
hammer drill with pneumatic hammering mechanism.
Handheld use is only allowed with the following tools in
Wear ear Wear safety
combination with the side handle TE-MAG. The letter „T"
protection footwear
in the name of the tools indicates that the tool is equiped
with a „dead-man switch".
The tool is available in various versions:
TE MD20 LS T
TE MD20 LS T HA
TE MD20 LS T IM
TE MD20 LS T PRCD
TE MD20 LS T HA PRCD
TE MD20 LS T EM
TE MD20 LS T EM PRCD (FFE: 2008154)
The TE MD20 LS T / TE MD20 LS T HA /
TE MD20 LS T EM / TE MD20 LS T IM are suitable for
use in areas where there is a risk of explosion and in
mining environments.

3. Insert tools and accessories

TE-MCE connection end
TE-MDR drill steel, in various lengths
TE-MDH drill bit head, in various versions
TE-MEC extension cord for use in areas where there is a
risk of explosion.
TE-MAC PRCD adapter cable for use only in areas where
no explosion protection is necessary; only applicable in
electric circuits where the nominal voltage is 220-230 V.
For rig-guided drilling:
TE-MW water leg in various lengths used in conjunction
with the TE MW 2G or TE MW 4G support base (and,
where necessary, with TE MW E water leg extension in
various lengths).
For handheld drilling:
Side handle TE-MAG
Pleas contact Hilti Customer Service for more informa-
tion about accessories.
(FFE: 2004397)
(FFE: 2008150)
(FFE: 2008151)
(FFE: 2008152)
(FFE: 2008153)
(FFE: 2051680)